Sony VPL-PX11 Mode D'emploi page 10

Location and Function of Controls
qh Lamp cover
qj Ventilation holes (intake)
qk Right speaker
ql Air filter cover lock
Used to remove the air filter cover.
For details, see "Cleaning the Air Filter" on page 33 (GB).
Note
Clean the air filter every 300 hours to ensure
optimal performance.
w; Ventilation holes (intake) / air filter cover
Notes
• Do not place anything near the ventilation holes as it
may cause internal heat build-up.
• Do not place your hand or objects near the
ventilation holes — the air coming out is hot.
How to use the adjusters
To adjust the height
Adjust the height of the projector as follows:
1
Lift the projector and press the adjuster buttons.
The adjusters will extend from the projector.
Adjuster buttons
10
(GB)
2
While pressing the buttons, adjust the height.
Then, release the buttons.
The adjusters will lock, then the height of the
projector will be fixed. For fine adjustment, turn
the adjusters to the right or left.
Note
If the adjusters have been extended to the limit
and you keep turning the adjusters
counterclockwise, the adjusters will stop turning
and the adjuster buttons cannot be pressed. In this
case, turn the adjusters clockwise, and then press
the adjuster buttons again.
3
If necessary, turn the rear adjusters to the right or
left to adjust the height of the projector.
Notes
• Be careful not to let the projector down on your
fingers.
• Do not push hard on the top of the projector with the
adjusters out.