Cleaning - Becker Centronic UnitControl UC52 Notice De Montage Et D'utilisation

Deleting intermediate positions
Press the intermediate position programming button
seconds. The intermediate position is now deleted.
The indicator lamp flashes briefly three times.
Programming ventilation/tilt position
Prerequisite: The roller shutter/blind is in the lower limit position.
1. Press and hold the ventilation/tilt position programming button
2. Also press the UP button until you reach the desired ventilation/tilt posi-
tion. Adjustments can be made using the UP button or DOWN button.
3. Release the ventilation/tilt position programming button
tion/tilt position is now saved.
The indicator lamp flashes briefly three times.
Deleting ventilation/tilt position
Press the ventilation/tilt position programming button
seconds. The ventilation/tilt position is now deleted.
The indicator lamp flashes briefly three times.
Only clean the device with a suitable cloth. Do not use aggressive cleaning
agents that may damage the surface.
26 - en

Cleaning

for more than 5
.
. The ventila-
for more than 5