Assembly / Connection - Becker Centronic UnitControl UC52 Notice De Montage Et D'utilisation

The device can be set as a drive controller or group control
unit via the coding switch on the rear.
Connection as drive controller
Caution
• Risk of injury due to electric shock.
• Connection may only be performed by a qualified techni-
cian!
Attention
•
If this unit is used to control more than one drive, the
drives must be decoupled by relay controls. There is no
need for decoupling in the case of Becker drives with
electronic limit switching.
• Always take into account the device switching current.
20 - en

Assembly / connection