Restoring The Factory Default Settings - tbs electronics Omnicharge2 OC2 12-40 Mode D'emploi

In order to de-activate the Power Supply mode again, jump to the setup mode by
pressing the MENU button for 3 seconds. Then exit the setup mode by pressing
MENU for 3 seconds again, while operating in the B1, B2 or B3 screens.
4.3

Restoring the factory default settings

When you wish to return to all default settings as shipped from the factory, you can use the
Reset command. To perform a factory reset action, press the MENU button for 3 seconds to
enter the setup mode. After this, please press the NEXT (>) button 4 times to reach the Reset
section as indicated below:
Configure battery bank 1
When the Reset section has been reach press the SET button once to jump to the End screen
of this section as indicated below:
Reset to factory defaults
After this, press the MENU button for 3 seconds to exit the setup mode. This will reset all
settings to the factory default values and jump back to the normal operating mode.
NEXT x4 Reset to factory defaults
SET End of Reset section
24