tbs electronics Omnicharge2 OC2 12-40 Mode D'emploi page 22

battery temperature will be used to calculate the charge voltage compensation level. Once
you have selected the desired value, press the SET button to jump to the next and final setup
parameter as indicated below:
Set battery temperature
This setup parameter represents the charge restart voltage and is indicated by the upper
three segments inside the battery icon. This is the voltage level at which the charger will
automatically restart the charging process (see chapter 3.3 for more info). This value can be
changed between 12.5V and 14.0V with a 0.1V step size. Once you have selected the desired
value, press the SET button to jump to the last step of setting up battery bank 1:
End of battery bank 1 setup
section
Now there are two options:
Press the MENU button for
3 seconds to save all
battery bank 1 setting and
jump back to the normal
operating mode
Changed battery parameters can be saved at any time in the setup mode by
pressing the MENU button for 3 seconds. So when you wish to only change one
specific parameter for example, there is no need to jump through all parameters
and reach an END screen for saving the changes.
SET Set charge restart voltage
Press the NEXT button once
to jump to the top level of
the setup menu and
OR
proceed with setting up
battery bank 2 and/or 3 as
21
well.