tbs electronics Omnicharge2 OC2 12-40 Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

This setup parameter represents the Absorption voltage and is indicated by the upper
segment inside the battery icon. For GEL, AGM and Flooded battery types, this value can be
changed between 13.9V and 15.0V with a 0.1V step size. For the Lithium battery type, this
value range ranges from 13.9V till 14.6V. Once you have selected the desired value, press
the SET button to jump to the next setup parameter as indicated below:
Set Absorption voltage
This setup parameter represents the maximum charge current and is indicated by a capital
'C' in front of the charge current value. You can choose between four values. The OC
in this example offers the following settings: 60A, 40A, 20A and 5A. Once you have selected
the desired value, press the SET button to jump to the next setup parameter as indicated
below:
Set maximum charge
current
This setup parameter represents the end of charge current value and is indicated by a lower
case 'c' in front of the current value. The end of charge current is the current level at which
the absorption stage ends and the charger finishes the charging process. You can choose
between three values and the level of these values is depending on the maximum charge
current setting. In this example where an OC
60A, the end of charge current values are: 12A, 6A or 3A. When choosing a lower maximum
charge current, the end of charge current values are also automatically lowered. Once you
have selected the desired value, press the SET button to jump to the next setup parameter
as indicated below:
Set maximum charge
SET
SET
Set end of charge current
2
12-60 is set to a maximum charge current of
19
current
2
12-60

Publicité

Table des Matières
loading

Table des Matières