Publicité
Les langues disponibles
Les langues disponibles
Setting your watch correctly
To set your watch correctly, proceed as follows:
• Release the crown by turning it to the left.
• Wind the movement (approximately 20 revolutions of the crown).
• Pull out the crown to position 1.
• Turn the crown to the right to advance the date display in steps. Set the
display to yesterday's date.
• Pull out the crown to position 2. This will stop the movement. To set the
time accurately to the second, it is best to stop the movement as the sec-
onds hand passes 60.
• Turn the hands forwards until the date display changes to today's date.
The hands will now be positioned between 12 midnight and 1 am.
• Now turn the hands forwards to the correct time. If you are setting the
watch in the afternoon, you must turn the hands past 12 (noon) again.
• Push the crown back to position 0 to start the movement.
• Now push the crown to position X and secure it by simultaneously turning
it to the right.
Important: Although the watch is water-resistant in positions 0, 1 and 2, the
crown should always be screwed in again for normal use (position X).
Reading the time in the dark
Both the dial and the hour and minute hands of your watch have luminescent
elements that allow you to read the time effortlessly, even in total darkness.
Publicité
