Publicité
Les langues disponibles
Les langues disponibles
The functions of the crown
X
Normal position
This watch has a screw-in crown. Screwing the crown in to its normal pos-
ition (X) prevents the inadvertent adjustment of the time or date and also acts
as a double seal to prevent water from seeping into the case. To release the
crown, unscrew it by turning it to the left, where it automatically assumes
position 0, the winding position. By depressing the crown in position X and
turning it to the right at the same time, it is screwed down firmly again and se-
cured.
Winding position
With the crown in the winding position (0), you can also wind the automatic
movement by hand. A few revolutions of the crown are enough to start the
movement. However, it is better to wind the watch by turning the crown
through approximately 20 revolutions as this will ensure maximum accuracy.
0
1
2
X
Normal position (screwed in)
0
Winding position
1
Date setting
2
Time setting
Publicité
