Cleaning - Beurer MP 70 Mode D'emploi

• We recommend applying a lanolin-based hand lotion to
the areas to be treated before treatment. This will help
you achieve a better result, and will make it easier to
remove the paraffin wax after treatment.
Warning
When using the paraffin bath on your feet, only use it sitting
down. Never stand in the paraffin bath.
• Briefly submerge the area to be treated (your hand, foot
or elbow) for 1-2 seconds in the liquid paraffin wax.
Remove your hand again and wait briefly until the wax
has solidified. During this time, do not move the treated
area, so that the wax can solidify properly.
• Repeat the process of submerging and pulling out six
to seven times, until several layers of paraffin wax have
formed over the treatment areas. If the paraffin wax is
either too hot or too cold for you during the treatment
period, turn the temperature controller clockwise or anti-
clockwise, to increase or decrease the temperature as
required.
• Now put a sheet on the treated area, press it onto the
paraffin wax and twist the end shut. Keep the sheet on
for 20 minutes.
Warning
If you are wearing the plastic sleevers on your feet, do not
run around in them. You could slip.
• After 20 minutes, take the sheet and the layers of wax off
the treated area. Dispose the sheet in the general waste;
it cannot be reused.
• After each use, take the protective grille out of the
paraffin bath.

8. Cleaning

Important
If the device is only being used by one person, change the paraffin wax at regular intervals and
clean the paraffin bath whilst doing so.
If the device is being used by several people, the paraffin wax should be changed before each
treatment for reasons of hygiene.
15
1-2 s
6-7 x