Replacement Parts And Wearing Parts; Disposal; Technical Data - Beurer MP 70 Mode D'emploi

• Pull the mains plug out of the socket.
• Take the protective grille out of the paraffin bath.
• Allow the paraffin wax to solidify overnight.
Warning
Do not use any sharp or pointed objects to remove the
wax block from the paraffin bath. You could damage or
scratch the paraffin bath.
• If the paraffin wax has solidified, press on one end
of the wax block and lift it out of the paraffin bath.
If the wax block cannot be removed easily, turn the
temperature controller to "warm" for ten minutes. Then
remove the mains plug and take the wax block out of
the paraffin bath.
• Then wipe the inside of the paraffin bath dry with a
clean towel.
Important
Never fill the paraffin bath with water in order to clean it.
• After cleaning, store the paraffin bath in a cool, dry and
dust-proof place.

9. Replacement parts and wearing parts

2 x 450 g of paraffin wax + 30 plastic sleevers
*
Commercially available or from the corresponding service address (according to the service address list)

10. Disposal

Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.

11. Technical data

Model no.
Voltage supply
Output
Protection class
Dimensions (L x W x H)
Weight
MP 70
220-240V~50/60Hz
80W
II / , IPX0
33 x 25 x 18 cm
1 kg
Item and/or order number
589.42*
16