Disposal; Replacement Parts And Wearing Parts - Beurer MP 42 Mode D'emploi

– Make sure that no water enters the instrument. But if this should happen,
do not use the instrument again until it is completely dry.
– Do not use chemical detergent or scouring agents for cleaning.
– Never immerse the instrument or plug-in power unit in water or other
liquids.

5. Disposal

In the interest of protecting the environment, the unit must not be thrown
out with the household waste at the end of its service life.
Dispose of the unit at a suitable local collection or recycling point.
Observe the local regulations for material disposal.
Please dispose of the device in accordance with EC Directive –
WEEE (Waste Electrical and Electronic Equipment).
If you have any queries, please contact the appropriate local autho-
rities.
You can find out about collection points for your old units e.g. from
the local municipal government, the local waste disposal company or your
dealer.

6. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding
listed service address under the stated material number.
Designation
Sapphire disk, fine
Sapphire disk, coarse
Sapphire cone
Felt cone
Sapphire callus rasp
Cylindrical milling cutter
Flame milling cutter
Protective cap for nail dust
Item number and/or order number
162.750
162.751
162.752
162.753
162.754
162.755
162.756
163.755
19