Operation - Beurer MP 70 Mode D'emploi

• Insert the mains plug into the socket (220-240V, ~50/60Hz).
The green operation light on the paraffin bath will light up.
The device is now switched on. The red heating light on the
paraffin bath will also light up, and will only go out when the
specified heat setting has been reached.
• Turn the temperature controller to "hot" to melt the paraffin
wax.
• Now place the lid on the paraffin bath and wait until the
paraffin wax has completely melted (around 2-3 hours).
Warning
If the paraffin bath is set to "hot", never dip your hands, feet or
elbows in the paraffin wax.
• As soon as the paraffin wax has completely melted, remove
the lid.
• Turn the temperature controller to the marked line between
"warm" and "hot".
• Lay the protective grille included in the delivery contents in the
liquid paraffin wax and wait until it has sunk to the bottom of
the paraffin bath.
• Put the lid back onto the paraffin bath and wait approximately
one hour, until the paraffin wax has cooled to an ideal
operating temperature (60°C).
Warning
The room temperature can affect the power of the device and
consequently the temperature of the wax.
Before submerging your hands, feet or elbows in the paraffin
bath, use the inside of your wrist to check that the temperature
of the wax is comfortable.
If a skin should form on the wax surface, increase the
temperature by turning the temperature controller clockwise. If
the paraffin wax is too hot for you, reduce the temperature by
turning the temperature controller anti-clockwise.

7. Operation

Warning
Before submerging your hands, feet or elbows in the paraffin bath, use the inside of your wrist to
check that the temperature of the wax is comfortable.
Warning
Take off your jewellery (e.g. watches, rings, etc.) before treatment.
After you have completed the necessary preparations from "Chapter 6 Initial use", you can begin
using the device. To start the treatment, carry out the following steps:
14