Midi Control; Adjusting The Midi Channel (Midi Ch); Controlling The Unit By Means; Of Midi Signals - IMG STAGELINE DMX-3216 Mode D'emploi

If the storage device connected is not compati-
NO Disk
ble, will appear on the display.
3) Press the number button of the program to be
loaded. If a program with this number has
already been saved to the storage of the con-
troller, it will be overwritten.
appear on the display; a status bar in the lower
line will indicate the progress of the load
process.
Once the program has been loaded,
OK
will briefly appear on the display.
If a number is selected where no program has
been saved on the storage device,
Error! will briefly appear on the display.
Repeat steps 2 and 3 to load further programs.

6.5 MIDI control

The DMX-3216 may be remote-controlled by
means of a MIDI signal. In addition, the controller, if
operated directly, generates MIDI signals at the
output MIDI OUT (29) that can, for example, control
a second DMX-3216. For this, first select the MIDI
channel to which the controller is to respond or on
which the controller is to send MIDI signals.

6.5.1 Adjusting the MIDI channel (MIDI CH)

1) Keep the button TAP (15) pressed for 3 s. The
LED above the button will start to flash;
ADDR:
xx (xx = current MIDI channel) will
appear on the display.
2) Use the control WAIT TIME (24) to adjust the
MIDI channel desired (1 – 16).
3) Keep the button TAP pressed until the LED
above the button stops flashing.
6.5.2 Controlling the unit by means of MIDI sig-
nals
1) To activate the MIDI control for the controller,
keep the button MIDI IN (14) pressed and also
press the button
button MIDI IN will light up;
appear on the display.
The controller can now be remote-controlled
by means of MIDI commands (
2) To deactivate MIDI control, keep the button MIDI
IN pressed and also press the button
LED next to the button MIDI IN will extinguish.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
Writing
Loaded
FILE
MIDI
(13). The LED next to the
MIDI In Mode
chapter 7.1).
. The
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may

6.6 Resetting the unit

Caution: The following procedure will delete all
scenes and all programs. All adjustments the user
may have made will be reset to their factory set-
tings. If required, save the programs on an external
device ( chapter 6.3) prior to resetting the unit.
will
1) Switch off the controller.
2) Keep the buttons MODE (20) and DEL (21)
pressed and switch on the controller. All LEDs
will flash briefly to confirm the procedure.
3) Release the buttons.
7

Specifications

Data protocol: . . . . . . . . . DMX 512
Number of
DMX channels: . . . . . . . . 512
Connections
DMX output: . . . . . . . . XLR jack, 3 poles
Audio input: . . . . . . . . 0.1 — 1 V
USB: . . . . . . . . . . . . . . jack type A
MIDI IN, OUT, THRU: . DIN jacks, 5 poles
Power supply: . . . . . . . . . via power supply unit
Ambient temperature: . . . 0 – 40 °C
Dimensions: . . . . . . . . . . 482 × 134 × 80 mm
Weight: . . . . . . . . . . . . . . 2.4 kg
will
, RCA
PP
provided, connected to
230 V~/50 Hz
3 RS
GB
25