Setup For; Maintenance And Inspection; Trouble Shooting; Environmental Protection - Jet JBOS-5 Mode D'emploi

7.3 Setup for 90°
Use a square (B, Fig 5) on the
sanding drum to exactly align the
table to 90°.
Loosen both knobs (A, Fig 5) and
place the table in the square position.
Fig 5
Set the 0° stop (E, Fig 5) so that it
rests against the table.
Set the pointer (C, Fig 5) so that it
reads 0°.

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Check sanding sleeves regularly for
faults. Replace a defective sanding
sleeve immediately.
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.
Defective safety devices must be
replaced immediately.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.

9. Trouble shooting

Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Sanding sleeve slips
*Sanding sleeve not clamped-
tighten sleeve clamping.
*Too much applied pressure
move workpiece while sanding.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*Sanding spindle is loose or spindle
cone is not clean.
Abrasive sleeve keeps tearing
*Sleeve is running the wrong direction-
observe arrow on the sanding sleeve
Sanded edge not square
*Table not square to sanding sleeve-
Adjust positive stop for 90°.
Sanding marks on the wood
*Workpiece was held still-
keep workpiece moving.
*Wrong grit sanding sleeve-
use coarser grit for stock removal
and fine grit for finish sanding.
*Feed pressure too high-
never force the wood.

10. Environmental protection

Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.

11. Available accessories

Stock number 709534
Complete 76mm spindle assembly
with rubber sanding drum and sleeve.
Stock number 709538
76mm rubber sanding drum and
sleeve.
Stock number 709539
76mm table insert
Refer to the JET-Pricelist
for various grit sanding sleeves.
6