STERWINS 40VHT2-60.1 Notice De Montage page 228

FR
Problems
ES
Product does
not start
PT
IT
The machine
EL
vibrates at
high speed
PL
The motor
stops while
operating
RU
The Motor is
KZ
ON, blades do
not move
UA
RO
Machine
suddenly
stopped
while cutting
hedge
EN
Product does
not reach full
power
Vibration
or noise is
excessive
Probable causes
On/off switch not set on ON
position
Only one of the two switch is
set on ON position
Internal parts damaged
The blade is out of balance
or worn
The motor shaft is twisted
Thickness of branches
exceeds capacity
The battery is discharged
The machine has damage
The blades are blocked
The Motor maybe occur
overload
The Motor maybe occur
overheat
The Battery maybe occur
overheat
Battery pack capacity too
low
Air vents are blocked
Bolts/nuts are loose
The machine has damage
Solutions
Refer to chapter "Start the
product"
Refer to chapter "Start the
product"
Turn off the motor, remove
the battery, inspect the
machine. Get the machine
repaired
Change the blade
Turn off the motor and
inspect the machine. Get the
machine repaired
Only cut branches complying
with the capacity
Recharge the battery
Do not use the machine and
speack to service center
Remove battery pack then
clear blockage from the
blades
Stop the machine and wait
for 3 minutes to restart
Stop the machine and wait
for the engine to cool before
switching it on again
Stop the machine and wait
for the battery to cool before
switching it on again
Charge battery pack
Clean the air vents
Tighten bolts/nuts
Do not use the machine and
speack to service center
228
Qualification
required
-
-
Approved
repair
centre
Approved
repair
centre
Approved
repair
centre
-
-
Approved
repair
centre
-
-
-
-
-
-
-
Approved
repair
centre