Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
These operating instructions apply to all IKA- S versions
Contents
Safety instructions
In order to be able to use the appliance properly and safely, every
user must first read the operating instructions and observe the
safety instructions contained therein. Take care of these operating
instructions and keep them in a place where they can be accessed
by everyone.
Only staff who have been trained accordingly, know the appliance
and are authorised to carry out work in this field should use this
appliance.
The machine may only be openend by trained specialists - even
during repairs. The machine is to be unplugged from the mains
18
before opening. Live parts inside the machine may still be live for
(e.g. A 11 basic S 1).
some time after unplugging from the mains.
The appliance can only be disconnected from the mains supply by
pulling out the mains plug or the connector plug. The socket for
the mains cord must be easily accessible.
Please follow the relevant safety instructions and guidelines, and
Page
occupational health and safety regulations for use in the labora-
tory.When working with the mill, the user must wear his personal
6
protective equipment. Defective or inappropriate protective equip-
18
ment can expose the user to the risk of
19
Please make certain that the mill is not tilted when it is in operati-
19
on and hold it in place with both hands.
19
Please ensure that there are no parts of the body between the
21
casing parts that move together.
22
Caution: Before removing the grinding beaker, switch off the mill
24
and wait until the motor stops. Risk posed by trailing crushing ele-
26
ments (beaters or cutters).
27
Always switch off the appliance and disconnect the plug before
27
cleaning or replacing parts.
28
Caution: The grinding beaker, crushing elements and rotor shaft
139
may be hot after long grinding cycles. Allow the mill to cool down
140
before cleaning or before changing crushing elements.
Caution: Beware of the sharp - edged cutter in particular when
changing crushing elements and when cleaning. Always wear
your personal protective equipment (protective gloves, etc.).
Please note that wear debris from the appliance or rotating acces-
sories can end up in the medium to be processed. Please contact
IKA should you have any questions in this respect.
The analytical mill A 11 basic may not been used in explosive
atmospheres or under water.
noxious substances. Please observe the relevant safety instruc-
tions and guidelines regarding dust explosions
Always wear suitable protective equipment when embrittling the
mill feed with coolants (liquid nitrogen or dry ice), (see laboratory
guidelines and accident prevention regulations applicable to the
laboratory).
spurting substances
.
Do not crush explosive, toxic or
.
102008
Publicité
Chapitres
Table des Matières
