Setting Up The System - Pioneer PDP-505HD Mode D'emploi

S U S
ETTING P THE YSTEM
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
8
Press 5/∞ to select FORMAT, then press
SET/SELECT.
SET UP
F O RMA T : C OMP O N E N T 1
C OMP O N E N T 2
R G B
E X I T
USE:
FORMAT can only be selected when "VIDEO" is set
in step 7.
9
Press 5/∞ to select the input signal format.
The table in the right column on this page shows what
settings are appropriate and available for the type of
connections made.
After selecting, press SET/SELECT to enter your
selection.
10
When the setup is completed, press MENU to exit
the menu screen.
Notes
÷ Make this setup for each input (INPUT3 and INPUT4).
÷ When selecting a PC signal or when SIGNAL is set to "PC",
FORMAT cannot be selected.
÷ When FORMAT is set to "COMPONENT" (1 or 2), "G ON
SYNC" cannot be set.
÷ Please refer to page 19 for details concerning G ON SYNC
setup.
18
<ARE1349> En
END: MENU
Set SIGNAL and FORMAT as follows.
SET UP
SIGNAL
Connected
component
Component video output VIDEO
of a DTV Set Top Box with
HDTV output
Component video output VIDEO
of a DTV Set Top Box with
SDTV output
Component video output VIDEO
of a DVD player, etc.
RGB video output of a VIDEO
video deck etc., with RGB
output
RGB video output of a PC PC
* Select either COMPONENT 1 or 2 depending on which setting
provides the most natural picture color for the component
connected.
Note
When a DTV Set Top Box is connected, please also refer to
"About DTV Set Top Box connection" on page 14.
FORMAT
COMPONENT 1*
COMPONENT 2*
COMPONENT 2*
RGB
RGB (Fixed to RGB
when SIGNAL is set
to "PC".)