Connection Panel - Pioneer PDP-505HD Mode D'emploi

P N F
ART AMES AND UNCTIONS
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

Connection panel

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
On this unit there are 4 input systems. There are also CONTROL terminals for connection of PIONEER components with
the Î mark. For details regarding a specific connection format, refer to the page written in parenthesis.
Bottom view
4
Y
C /P C /P
B B R R
G B R HD
[ON SYNC] INPUT3 [H/V SYNC]
1
CONTROL IN/OUT
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables
control of this unit as a component in a system
(page 15).
2
FACTORY ADJUSTMENT TERMINAL
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
3
INPUT4
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from
the connected component (pages 11 to 13).
4
INPUT3
For connection of components that have RGB or
component output jacks such as a personal computer,
DVD player, or external RGB decoder (pages 11 to 13).
8
<ARE1349> En
1 2
IN OUT
FACTORY ADJUSTMENT
CONTROL
TERMINAL
5 6 7
75Ωj2.2kΩ Y C /P C /P
B R R
B
VIDEO
VD C-VIDEO
INPUT2
INPUT1
ANALOG
S-VIDEO
5
Synchronizing signal impedance selector switch
Depending on the connections made at INPUT3, it
may be necessary to set this switch to match the
output impedance of the connected component's
synchronization signal.
When the output impedance of the component's
synchronization signal is above 75 Ω, set this switch
to the 2.2 kΩ position (pages 12 and 13).
6
INPUT2
For connection of DVD player with component video
output (page 10).
7
INPUT1
For connection of components that have an S-video or
composite video output jack such as a video deck,
video camera, laser disc player, or DVD player (page 10).
Note: It is possible to have connections made to both
the VIDEO and S-VIDEO jacks at the same time.
However, if simultaneous signals are received, the
S-video signal is given priority (page 10).
8
AC INLET
Use to connect the supplied power cord to an AC
outlet (page 15).
3
R G B
INPUT4
8
AC INLET