Setting Up The Remote For On-Screen Control; Using The Remote; Inserting Batteries Into The Remote - Sony TA-VE810G Mode D'emploi

Setting Up the Remote for On-Screen Control

Using the Remote

Inserting batteries into the remote

1
Open the cover on the
bottom of the remote.
2
Insert two size AA (R6) batteries with correct
polarity (+/–), then close the cover.
Notes on the remote
Battery life
Under normal use, the batteries should last for about 6
months. When the remote no longer operates the amplifier,
replace both batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid
place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
b
Turning on the amplifier and bringing up
the on-screen display on your TV (or
monitor)
To turn on the amplifier, point the remote at the IR
receptor, and then press the direction control button on
the remote once or twice. To bring up the on-screen
display, turn on your TV and set it to the appropriate
video input. If you register the IR code of your TV (see
"Registering a TV (or Monitor)" on page 13), you can
turn on your TV automatically whenever you turn on
the amplifier.
IR receptor
Direction
control
button
PUSH
ENTER
(continued)
GB
11