Connecting The Power To The Unit - Ingeteam INGEREV GARAGE Basic GB120-C1 Manuel D'installation Et Usage

Installing and connecting the unit
In the event that it is not installed at the bottom of the unit, the support must be secured to the wall as
shown in the following image.
3. Check that the unit properly secured.

7.2.2. Connecting the power to the unit

Cabling requirements
The connection must meet certain requirements:
Connection specifications
Connection type
Number of conductors
Nominal current
Conductor maximum diameter
Connection process
In order to connect the unit it is not necessary to open its front enclosure. A window is located at the bottom of the
unit, to access the terminal block to which to make the connection.
Upon receiving the unit the cover of this window is not installed.
ABA2021IQM01_A - Installation and Operation Manual
Single phase Three phase
2P + E 3P + N + E
up to 32 A up to 32 A
10 mm (2 x 6 mm )
2 2
Ingeteam
EN
ES
FR
IT
19