Ingeteam INGEREV GARAGE Basic GB120-C1 Manuel D'installation Et Usage page 31

Operation
2. Connect the vehicle to the charging station.
Ending the charging process (without a card reader)
To finish the charge cycle insert the key and turn it to the 0 position. The front LEDs flash yellow when waiting for
a vehicle to be disconnected. Remove the connector from the vehicle.
Starting the charging process (with a card reader)
1. Check that the charging station is in awaiting vehicle status (green light).
2. Place the card next to the reader on the front of the station. When the station reads the card correctly the
light will flash yellow, meaning it is waiting for the vehicle to be connected.
If the key is in 0 or N position the charge will be done with nominal power. If you want to charge with
limited power, turn the key clockwise to the L position. It is possible to change the type of charge during
the charging process by turning the key to the desired position. The key can be left inserted or removed,
depending on the user's requirements. Removing the key ensures that the charge process selection is not
modified by third parties.
ABA2021IQM01_A - Installation and Operation Manual
Ingeteam
EN
ES
FR
IT
31