Unit Description; Models; Compliance With Regulations; Emc Requirements - Ingeteam INGEREV GARAGE Basic GB120-C1 Manuel D'installation Et Usage

Ingeteam

2. Unit description

2.1. Models

The models of the INGEREV range are:
INGEREV GARAGE Basic
INGEREV GARAGE Basic GB120-C1 (single phase)
INGEREV GARAGE Basic GB132-C1 (single phase)
INGEREV GARAGE Basic GB120-C2 (single phase)
INGEREV GARAGE Basic GB132-C2 (single phase)
INGEREV GARAGE Basic GB332-C2 (three phase)
INGEREV GARAGE Wall
INGEREV GARAGE Wall GW116 (single phase)
INGEREV GARAGE Wall GW132 (single phase)
INGEREV GARAGE Wall GW332 (three phase)
INGEREV GARAGE One
INGEREV GARAGE One GO132 (single phase)
INGEREV GARAGE One GO332 (three phase)

2.2. Compliance with regulations

CE marking
CE marking is mandatory for the sale of any product within the European Union, without prejudice to standards or
laws. These charging stations have the CE marking because of their compliance with the following directives:
• Low Voltage Directive 2014/35/EU.
• Electromagnetic Compatibility Directive 2014/30/EU.
To comply with each directive, compliance with the parts applicable to our units of the appropriate harmonized
standards is sufficient.
Low Voltage Directive
These charging stations sufficiently comply with this directive by means of compliance with the applicable parts of
harmonized standard EN 61851 Electric vehicle conductive charging system.
Electromagnetic Compatibility Directive
These charging stations sufficiently comply with this directive by means of compliance with the applicable parts of
harmonized standards:
• EN 61000-6-2 Electromagnetic Compatibility. Part 6-1: Generic standards - Immunity for residential,
commercial and light-industrial environments.
• EN 61000-6-3 Electromagnetic Compatibility. Part 6-3: Generic standards - Emission for residential,
commercial and light-industrial environments.
Compliance with these standards calls for compliance with limits and procedures in other standards of the same
series.

2.3. EMC requirements

These charging stations have the necessary filtering elements to comply with EMC requirements for domestic
applications in order to prevent disturbances in other equipment outside the installation.
8 ABA2021IQM01_A - Installation and Operation Manual
Unit description