Fit The Upper Screw; Connect The Charger To The Power - Ingeteam NEO Manuel D'installation Et Usage

Installation
3. Fit the wall plugs.

3.1.7. Fit the upper screw

Fit the screw of the upper part and tighten it until there is a 4 mm gap between the screw head and the wall.
CAUTION
In the case of the STAND, use the screws that come with it in the packaging.

3.1.8. Connect the charger to the power

Connect the electrical terminals of the power cable to the corresponding points on the charger.
CAUTION
Make sure that all screws are suitably tightened for effective contact of the active elements of the conductor.
ABV2011IQM01_ - Installation and Operation Manual
1
2
3
4 mm
Wall mounting: 5.4x45 screw
STAND assembly: M5x12 screw
Ingeteam
EN
ES
FR
IT
8 mm
11