Before Machine Start-Up - Clarke RA40 Mode D'emploi

ENGLISH

BEFORE MACHINE START-UP

WARNING!
When starting the machine, or before operating the "One Touch" button (42), make sure that there is no foreign
material between the deck and the tank assembly which could obstruct the deck movement. If the machine has
been turned off without lifting the deck, the deck would lift automatically at next machine start-up.
Brush or pad-holder removal/installation
1. According to the kind of cleaning to be performed, the
machine can be equipped either with the brush (A, Fig.
2) or the pad-holder (B) with pad (C) together with the
appropriate deck.
2. Place the brush (A) or the pad-holder (B) under the deck
(7).
3. Turn the ignition key (41) to "I".
4. Press the push-button (42) to lower the deck on the brush.
5. To engage the brush, press the drive pedal (2) shortly, if
necessary repeat the procedure until the brush is engaged.
6. To remove the brush, lift the deck by pressing the push-
button (42), then manually release the brush from the hub
by turning it abruptly in its normal rotation direction (D).
Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
12
INSTRUCTIONS FOR USE
46 GRIT 80 GRIT
RA40 - 9100000394
B
C
180 GRIT 240 GRIT 500 GRIT
A
D
Figure 2
PROLENE PROLITE UNION MIX
P100864
01/2015