Before Machine Start-Up - Clarke Vantage 14 Mode D'emploi

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal
NOTE
Install either the brush (A, Fig. 1) or the pad-holder (B and C) according to the type of loor to be cleaned.
1. Lift the brush/pad-holder deck (12) using the handlebar (1).
2. Place the brush (A, Fig. 1) or the pad-holder (B and C) under the deck (12).
3. Lower the deck (12) by using the handlebar (1).
4. Turn the knob (32) on one of the indicated programs.
5. Press the enabling push-button (39) together with the brush levers (40) to engage the brush/pad-holder.
To remove the brush/pad-holder, perform the following procedures.
6. Switch off the machine by turning the knob (32) to "0".
7. Lift the machine deck using the handlebar (1), then manually release the brush/pad-holder from the hub, by turning it abruptly
in its normal rotation direction (D, Fig. 1).
A
Available brushes and their relevant application guides (suggestions only and see Recommended spare parts
for part numbers)
Models
Concrete
Terrazzo loor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
Solution tank illing
Open the iller neck (21), ill the tank (22) with a solution suitable for the work to be performed. Do not ill the solution tank
8.
completely, leave a few inches from the top. Always follow the dilution instructions on the label of the chemical product used to
prepare the solution. The solution temperature must not exceed 104° F (40°C).
CAUTION!
Use only low-foam and non-lammable detergents, intended for automatic scrubber applications.
Adjustments
9. Adjust the height and the inclination of the handlebar (1) with the lever (2) to reach a comfortable position.
Instructions For Use - VANTAGE 14
B
C
D
Front
Figure 1
MIDLITE GRIT 180 MIDGRIT 240
ENGLISH
D
P100407
PROLITE UNION MIX
11