After Using The Machine; Machine Long Inactivity; First Period Of Use; Maintenance - Clarke Vantage 14 Mode D'emploi

ENGLISH

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Empty the tanks (23 and 22) as shown in the previous
paragraph.
2. Perform the daily maintenance procedures (in the following
paragraph).
3. Store the machine in a clean and dry place, with the brush/
pad-holder and the squeegee blades lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the procedures shown in the previous paragraph.
2. Open the cover (4) and disconnect the battery connector
(7).
3. Store the machine in a clean and dry place.
4. To safeguard the brush or squeegee blades, turn the
handlebar (1) forward and park the machine as shown in
igure 3.

FIRST PERIOD OF USE

After the irst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. The following chart
provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be
deined by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the battery/battery charger cable
disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualiied personnel, or by an authorized Service
Center. This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Squeegee cleaning
Brush cleaning
Tank and vacuum grid cleaning
Squeegee blade check and/or replacement
Battery charging
Screw and nut tightening check
Brush deck rubber pad check and/or replacement
Brush deck end-of-stroke cable check and/or replacement
Brush deck rubber lange check and/or replacement
And after the irst 8 working hours.
(1)
(2) For the relevant procedure, refer to the Service Manual.
14
Figure 3
Daily, after using
Weekly
the machine
Instructions For Use - VANTAGE 14
P100451
Every six
Yearly
months
(1)
(2)
(2)
(2)