EUROM CoolStar Manuel D'utilisation page 17

Operation
Insert the plug into the socket. The unit is now ready for use.
- By pushing on the LOW, MIDDLE or HIGH, you start ventilation on low, medium
or high power.
- By pushing the COOL button next, you start the cooling function. The pump
circulates water from the reservoir via the water curtain, where it partially
evaporates, thus ensuring cooling. By pushing this button again, the function is
disabled again.
- The SWING button makes the breeze swivel from left to right horizontally.
Pressing it again switches this function off. By adjusting the horizontal panels
manually, you can adjust the vertical outlet direction.
- By pushing the OFF button, you switch off the ventilation function. To switch off
the device, all 3 functions must be switched off separately! Then always remove
the plug from the socket.
TAKE NOTE OF THE WATER LEVEL DURING OPERATION!
Cleaning and Maintenance
Switch off the equipment and remove the plug from the socket before cleaning or
carrying out maintenance work.
 Wipe the outside of the equipment regularly with a dry or slightly damp cloth. Do
not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions! Ensure that the operating panel does not get wet.
 Use a vacuum cleaner to carefully remove any dust and dirt from the grills and
ensure that the air intake and outlet openings are clean. Be careful not to touch
or damage any internal parts during cleaning!

In order to avoid the creation of odours and
ensure the unit works properly, it must be
cleaned internally once every two weeks.
Remove the front panel (X) by loosening the two
attachment pins and lifting the panel upwards, off
the 2 upper attachment points. Release both
screws (Y) to the left and upper right and remove
the filter with the water screen (Z) from the
device. Clean filter and water screen gently with
a soft brush or under a slowly flowing tap and
allow them to dry thoroughly. Refit all the parts in
17