EUROM CoolStar Manuel D'utilisation page 16

Description
The CoolStar evaporates water with heat that is removed from the room and sends
the cool, humid air back into the room: a process that can be compared to wind
blowing across water.
The CoolStar has the following functions:
- Ventilation (3 power settings)
- Ventilation, cooling and humidifying (3 power settings)
- Rotation
Installation and Preparation
 Remove the packaging and place the unit straight, on a sturdy, flat and horizontal
surface. Ensure there is sufficient space at the front (air outlet and air inlet). The
back of the unit may rest against a wall, if necessary.
 Check whether the socket that you wish to use provides the required voltage, as
detailed on the specification plate.
 Pull the water reservoir roughly 7 cm backwards and fill with clean water; Fill the
reservoir above the "MIN"- but below the "MAX" level.
 If you require extra cooling, you could add frozen ice packs in the water reservoir
(not included).
 If you wish to use the humidification function, ensure there is sufficient water in
the reservoir.
 If you have not used the unit for some time, refresh any remaining water.
ALWAYS UNPLUG THE POWER CORD WHEN
YOU POUR WATER IN OR OUT OF THE TANK!
A. Operation panel
B. Air outlet
C. Air inlet
D. Front panel
E. Handle
F. Back cover
G. Water reservoir clip
H. Water reservoir
I. Water tank instructions
16