General Cleaning - Whirlpool GERC4110PB0 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Styles 2 & 3 - Electronic Oven Control
Before self-cleaning, make sure the door is closed completely or
it will not lock and the cycle will not begin.
1. Press AUTO CLEAN.
2. Press the TEMP/TIME "up" or "down" arrow pad to set a
clean time other than 3 hours 30 minutes. The clean time can
be set between 2 hours 30 minutes and 4 hours 30 minutes.
3. Press START/ENTER.
The oven door will automatically lock. The ON, CLEAN and
DOOR LOCKED oven indicator lights will light up. The door
will not unlock until the oven cools.
When the cycle is complete and the oven cools, the oven
display and the oven indicator lights will go off.
4. Press OFF/CANCEL to clear the oven display.
To Delay Start Self-Clean:
Style 1 - Electronic Oven Control
Before delay of starting Self-Clean, make sure the clock is set to
the correct time of day. See "Clock" section. Also, make sure the
door is closed completely or it will not lock and the cycle will not
begin.
1. Press AUTO CLEAN to set a clean time for 2 hours
30 minutes (Quick Clean). Press AUTO CLEAN again to set a
clean time for 4 hours 30 minutes (MAXI CLEAN).
2. Press DELAY.
3. Press HR and MIN "up" and "down" pads to enter the time of
day to stop.
4. Press START.
The start time is automatically calculated and displayed. The
door will automatically lock at the set start time, and DOOR
LOCKED or LOCKED and DELAY and the stop time will also
appear on the display (on some models). The door will not
unlock until the oven cools.
When the start time is reached, the oven will automatically
turn on.
When the cycle is complete and the oven cools, DOOR
LOCKED or LOCKED will disappear from the display.
5. Press OFF/CANCEL to clear the oven display.
Style 2 - Electronic Oven Control
Before delay starting Self-Clean, make sure the clock is set to the
correct time of day. See "Clock" section. Also, make sure the door
is closed completely or it will not lock and the cycle will not begin.
1. Press AUTO CLEAN to set a clean time to HI (4 hours
30 minutes). Press AUTO CLEAN again to change the setting
to LO (2 hours 30 minutes).
2. Press STOP TIME.
3. Press START.
The start time is automatically calculated. The door will
automatically lock, and DOOR LOCKED or LOCKED and
DELAY and the stop time will also appear on the display (on
some models). The door will not unlock until the oven cools.
When the start time is reached, the oven will automatically
turn on.
When the cycle is complete and the oven cools, "End" will
appear on the oven display and DOOR LOCKED or LOCKED
will disappear from the display.
4. Press OFF/CANCEL to clear the oven display.
22
Style 3 - Electronic Oven Control
Delay Start Self-Clean is not available on Style 3 Oven Control.
To Stop Self-Clean anytime:
If the clean function is terminated while the oven cavity
temperature is greater than 500ºF (260ºC), the oven door will
remain latched until the oven cavity temperature is below this
threshold.
Style 1 - Electronic Oven Control
Press OFF/CANCEL. If the oven temperature is too high, the door
will remain locked. It will not unlock until the oven cools. If the
oven temperature is too high after self-cleaning, then LOCKED
will appear on the display until the oven completely cools.
Style 2 - Electronic Oven Control
Press OFF/CANCEL. If the oven temperature is too high, "cln,"
TIMED, ON, "cool," and LOCKED will appear on the display (on
some models), and the door will remain locked. It will not unlock
until the oven cools.
Style 3 - Electronic Oven Control
Press OFF/CANCEL. If the oven temperature is too high, the door
will remain locked. It will not unlock until the oven cools.

General Cleaning

IMPORTANT: Before cleaning, make sure all controls are off and
the oven and cooktop are cool. Always follow label instructions
on cleaning products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
EXTERIOR PORCELAIN ENAMEL SURFACES
(on some models)
Food spills containing acids, such as vinegar and tomato, should
be cleaned as soon as the entire appliance is cool. These spills
may affect the finish.
Cleaning Method:
Glass cleaner, mild liquid cleaner or nonabrasive scrubbing
pad: Gently clean around the model and serial number plate
because scrubbing may remove numbers.
All-Purpose Appliance Cleaner Part Number 31662B (not
included):
See "Assistance or Service" section to order.
STAINLESS STEEL (on some models)
Do not use soap-filled scouring pads, abrasive cleaners, Cooktop
Polishing Creme, steel-wool pads, gritty washcloths or some
paper towels. Damage may occur.
Rub in direction of grain to avoid damaging.
Cleaning Method:
Stainless Steel Cleaner & Polish Part Number 31464B (not
included): See "Assistance or Service" section to order.
Liquid detergent or all-purpose cleaner: Rinse with clean
water and dry with soft, lint-free cloth.
Vinegar for hard water spots

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gerc4110pb2

Table des Matières