Installing Front Handle - Ryobi RY43200 Manuel D'utilisation

INSTALLING FRONT HANDLE

See Figures 3 - 4.
Install the front handle so that the short side of the
handle is on the same side as the motor.
 Disconnect the lopper from the power supply.
 Rotate the front handle knob counterclockwise
to remove. Set knob and washer aside.
 Remove the bolt cover and bolt.
 With the jaws of the lopper closed, install the
front handle in the vertical upright position.
WARNING:
Never position the front handle so that it is for-
ward of the vertical upright position. Positioning
the handle in this forward area could cause the
operator to lose control of the lopper and result
in serious personal injury.
 Reinstall the bolt and bolt cover.
 Reinstall the washer and front handle knob;
rotate knob clockwise to tighten securely.
ASSEMBLY
FRONT
HANDLE
KNOB
WASHER
DO NOT POSITION HANDLE FORWARD
OF THE VERTICAL UPRIGHT POSITION
Page 11 — English
FRONT
HANDLE
SHORT
SIDE
BOLT
BOLT
COVER
MOTOR
Fig. 3
Fig. 4