Applications; Installing/Removing Battery Pack - Ryobi P2804 Manuel D'utilisation

NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.

APPLICATIONS

You may use this product for the purpose listed below:
 For use with most consumer grade home and garden
chemicals such as insecticides, fungicides, weed killers,
and fertilizers

INSTALLING/REMOVING BATTERY PACK

See Figure 7.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Raise the battery cover.
 Align the raised rib on the battery pack with groove in the
battery port and place the battery pack in the tool.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
 Lower the battery cover.
To remove:
 Depress the latches on both sides of the battery pack to
release the battery pack and remove it from the tool.
WARNING:
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
TURNING THE SPRAYER ON/OFF
See Figure 8.
 To turn the sprayer ON, press the ON/OFF button.
 To start the flow of liquid at the spray wand, squeeze the
trigger.
 To stop the flow of liquid at the spray wand, release the
trigger.
 To turn the sprayer OFF, press the ON/OFF button again.
OPERATION
LOCK-ON
See Figure 9.
The lock-on feature is convenient when spraying for an ex-
tended period of time or when covering a large area.
 To lock-on, squeeze the trigger and slide the locking tab
backward.
 To release the lock-on, squeeze the trigger and slide the
locking tab forward.
NOTE: Make sure the trigger is not locked on before
inserting the battery pack into the sprayer.
FILLING THE TANK
See Figure 10.
Before filling the tank, always remove the battery pack
and ensure the battery cover is closed. Wipe up any spills
before inserting the battery pack. Following this rule will
reduce the risk of electric shock and corrosive liquids
entering the battery pack, which can cause battery pack
failure including short circuit resulting in smoke, fire, and/
or serious personal injury.
Always follow the chemical manufacturer's instructions
printed on their product labeling for use, cleaning, and
storage. Clean thoroughly after each use, following the
instructions in the Maintenance section of this manual.
Chemicals should be stored out of the reach of children.
Failure to do so may result in serious personal injury.
Do not allow conductive or corrosive fluids to get inside
the battery pack. If conductive or corrosive fluids are
spilled on the battery, refer to the instructions in your
battery operators manual.
Liquids to be sprayed must be as thin as water. Thicker
liquids will not spray properly.
Do not overfill the tank.
NOTE: A removable strainer prevents debris that can clog or
damage the pump from entering the tank. It may be removed
when using a funnel or for cleaning. Always reinsert strainer
before reinstalling cap.
 Remove the battery pack.
 Unscrew the cap and remove it from the tank.
 Fill the tank with the desired amount of water (up to
4 gallons).
9 — English
WARNING:
WARNING:
WARNING: