Operation; Applications - Ryobi RY15519 Manuel D'utilisation

 Push in the button located on the blower attachment.
Align the button with the guide recess on the power head
coupler and slide the two shafts together. Rotate attach-
ment shaft until button locks into the positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shaft is not locked into place. Slightly
rotate from side to side until the button is locked into
place.
 Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during use
to avoid serious injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:
 Clearing leaves and other debris from your lawn
 Keeping decks and driveways free from leaves and pine
needles
ASSEMBLY
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
 Stop the engine or motor and remove the spark plug wire
or disconnect from the power supply.
 Loosen the knob.
 Push in the button and twist the shafts to remove and
separate ends.

OPERATION

USING THE BLOWER ATTACHMENT
See Figure 4.
When using the blower attachment, hold the unit with your
right hand on the rear handle and your left hand on the front
handle. Keep a firm grip with both hands while in operation.
The blower should be held at a comfortable position with
the rear handle about hip height.
NOTE: Carry the unit slightly above ground level. Do not
drag or push it along on the ground as the housing will
wear quickly.
OPERATING TIPS
 To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
 You will find that it is no longer necessary to move objects
to effectively clean around them. A simple blast from the
blower will move debris from those difficult to reach and
often impossible to clean areas.
 The ground level air blast is ideal for practically all sweep-
ing jobs.
7 — English