Features; Assembly - Ryobi RY15519 Manuel D'utilisation

KNOW YOUR BLOWER ATTACHMENT
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
UNPACKING
This product requires assembly.
 Carefully remove the items from the box. Make sure that
all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Ryobi Expand-It Blower Attachment
™
®
Blower Attachment Shaft
Attachment Securing Cap
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.

FEATURES

PRODUCT SPECIFICATIONS
Weight ........................................................................ 4 lbs.
Air Velocity:
MPH ........................................................................ 150
CFM ........................................................................ 279

ASSEMBLY

WARNING:
Do not connect to power head until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
JOINING THE BLOWER ATTACHMENT TO THE
ATTACHMENT SHAFT
See Figure 2.
Use the attachment securing cap for the one-time assembly
of the blower attachment to the attachment shaft.
 Install the attachment securing cap over the end of the
attachment shaft as shown.
 Align the raised tabs inside the opening on the blower
housing with the positioning holes on the attachment
shaft. Insert the end of the attachment shaft into the
opening on the blower housing and rotate slightly until
the tabs lock into the positioning holes.
 Rotate the attachment securing cap clockwise until the
shaft is completely secure.
NOTE: When fully secure, the cap cannot be rotated
counterclockwise.
JOINING THE POWER HEAD TO THE
BLOWER ATTACHMENT
See Figure 3.
WARNING:
Never attach or adjust any attachment while power head
is running. Failure to stop the engine or motor may cause
serious personal injury.
After assembling, install the blower attachment onto the
power head using the coupler device.
 Remove the spark plug wire or disconnect from the power
supply.
 Remove the hanger cap from the attachment shaft.
 Loosen the knob on the coupler of the power head shaft.
6 — English