Cleaning, Storage, Disposal - Beurer Janonh JFT 60 Mode D'emploi

error
message Problem
(1) Forehead thermometer mode: the tempera-
ture measured is lower than 34 °C (93.2 °F).
(2) SCAN mode: the temperature measured is
lower than -22 °C (-7.6 °F).
Autotest not successful.

8. cleaning, storage, disposal

Clean the sensor tip after every use. Use a clean cloth or cotton bud that can be moistened with disinfectant, alcohol or
warm water.
To clean the entire device, use a soft cloth slightly moistened with a mild soapy solution. Water must never get into the
device. If water gets into the device, remove the battery immediately. Only use the device again when it is completely dry.
Do not use any harsh cleaning agents.
Never immerse the device in water.
Always store the thermometer with the cap on in order to protect the sensor.
The device must not be stored or used at too high or low a temperature or humidity (see technical specifications), in sun-
light, in association with an electrical current or in dusty locations. Otherwise, inaccuracies can occur.
If prolonged storage is intended, you should remove the battery.
The device must be tested for accuracy (calibrated) after 3 years. Please send the complete device to the dealer's or
service address.
Please dispose of the device in accordance with the directive 2002/96/EG – WEEE (Waste Electrical and Electronic
Equipment). If you have any queries, please refer to the local authorities responsible for waste disposal.
Solution
Operate the thermometer only between the specified tempera-
ture ranges. If necessary, clean the sensor tip. In the event of
a repeated error message, contact your dealer or customer
service.
Insert new battery.
17