Tare Function; Usage - Beurer BY 90 Mode D'emploi

Transfer of the measurements
A maximum of 10 measurements can be stored�
• Press the Bluetooth
is opened� The Bluetooth
is a successful connection until the data is transferred� After successful transfer of the
measurements, the scale switches off automatically�
Deactivating the AUTO HOLD function
If you wish to use the baby scale without the AUTO HOLD function, you can deactivate the
AUTO HOLD function�
1� Once "0.000 kg" appears on the display, the AUTO HOLD function can be deactivated by
pressing the HOLD button for 3 seconds�
2� As soon as "0.000 kg" appears on the display, the baby scale is ready to take measurements�
3� Now place the baby on the weighing surface� Do this very carefully; do not let the baby fall
and take particular care with the baby's head�
4� To establish the baby's weight, press the HOLD button� The recording of the weight is con-
firmed in the display when the HOLD symbol flashes for 5 seconds�
5� The weight is displayed for 120 seconds and then it switches off automatically� Press the
ON/OFF/TARE button
baby scale, press and hold the ON/OFF/TARE button
6� To reactivate the AUTO HOLD function, press and hold the HOLD button for 3 seconds�
Note: If the HOLD symbol + ON appear in the display, the AUTO HOLD function is activated�

TARE function

If you prefer not to place the baby directly onto the weighing surface, but instead onto a hand
towel, for example, you must place the hand towel on the baby scale before switching it on�
If you have placed a towel or other objects on the baby scale when it is already switched
on and you would like to remove these again before weighing, you can also use the TARE
function� Once you have pressed the TARE button, "TARE" is shown in the display� To reset
the baby scale to "0,000 kg", you have to remove the towel or additional weight from the
baby scale and press the TARE button again�
Using the tape measure
Pull out the tape measure on the top of the baby scale if you
want to measure the baby� In order to reel the tape measure
back into the baby scale, press the round button next to the tape
measure on the bottom of the baby scale� You can manually
enter the height and head circumference of your baby in the
"beurer BabyCare" app�

7. Usage

Saving the measured values on the baby scale and transferring them to the app
A maximum of 10 measurements can be saved in the baby scale� The saved measurements
are transferred automatically to the app if you open the app within the Bluetooth
Bluetooth is switched on on the scale�
®
It is not possible to automatically transfer data when the baby scale is switched off�
button � starts to flash in the display (120 seconds) until the app
®
symbol is then shown continuously in the display when there
®
to take another measurement� In order to manually switch off the
for 3 seconds�
19
range and
®