Id, Time And Date Settings; Date & Time Settings; Id Number Setting; Take A Measurement - Henry Schein 900-8275 Manuel D'utilisation

ENGLISH
the battery voltage is lower than 3.5±0.1V the unit will shut down.
Cautions!
Do not use batteries that are not specified for this unit.
o
Do not dispose of batteries in fire.
o
If battery fluid should get on your skin or clothing, immediately rinse with plenty of clean water.
o
Remove the batteries if the unit is not used for extended period. (Approximately three months or more).
o
Do not use new and used batteries together.
o
Dispose of batteries in accordance with the local ordinances and regulations.
o
Warning!
DO NOT USE Ni-MH rechargeable and alkaline batteries together, otherwise, that may cause damage to the
device or injury to users.
Notes:
1. The "Brightness" cannot be set during the charging process.
2. It is not recommended to take measurements during the charging process, as this may damage the
device or possibly injure users.
3. DO NOT charge when the non-rechargeable batteries are installed, as this may damage the device or
possibly injure users.
Always set the date and time before using the unit for the first time. Set different ID numbers for different users.
The date and time are important indicators when a measurement is taken.
3.1 Date & Time Settings
Set the correct time according to the following steps:
1. Power on the pulse oximeter and then press the menu button to enter the main menu, refer to
Fig.3-1.
Fig.3-1
2. Select the "System Setup" item in the main menu; this will enter its corresponding sub-menu as
shown in Fig.3-2. Pick and enter the "Time/Date" item.
3. Pick different sub-items to set and press the MENU button to set and then press the Up or Down
button to adjust the value. Press the MENU button again to confirm your settings.
The date is displayed in the order of Year-Month-Day and Time is displayed Hour-Minute-Second.

3.2 ID Number Setting

Enter the "User ID Setup" item from the main menu screen, refer to Fig.3-1. Press the MENU button to place
ID number on as shown in Fig.3-4, and then press the UP or DOWN button to increase or decrease the ID
number, press the MENU button again to confirm your setting. The range of ID number is: 001-127.

4.1 Install the Probe

1. Before use, check the pulse oximeter for mechanical damage.
2. Insert the SpO probe into the probe socket (refer to Fig.4-1). The indicator
2
which indicates the probe is fully connected. If the SpO

3. ID, Time and Date Settings

Fig.3-2
Fig.3-4

4. Take a Measurement

6
Fig.3-3
probe is disconnected from the unit, the indicator
2
appears on the screen,