Lifting The Vehicle; Lowering The Vehicle - ATT Nussbaum SPRINTER MOBIL 2500 Manuel D'exploitation

in rails.
Vehicle with front-wheel drive:
Vehicle with rear-wheel drive:
5.1

Lifting the vehicle

Warning! The hydraulic lines may not be driven
!
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
The total centre of mass must be considered.
!
60
i
• Secure the vehicle against rolling; pull the hand
brake, engage the gears.
The center of gravity
• Inspect the hazardous area.
of the vehicle in-
No person or object may stand in the working
cluding load must
area of the lift, or on the lift.
be between 100
• Switch on controls. Turn the main switch (2) to po-
mm and 600 mm
sition „1" (see figure 007).
from the stationary
• Position polymer overlays below the points spec-
bearing towards the
ified by the vehicle manufacturer. The polymer
middle of the lift.
overlays may not be placed on edge, otherwise
the vehicle could fall.
fixed bearing
• Lift the vehicle. Push the „LIFT" (3) button.
• If the wheels are not blocked, interrupt the lifting
CG = center of gravity
process and check for proper seating of the poly-
mer overlays.
fixed bearing 008
• Raise the vehicle to the desired working height.
• Then position the operating unit in such a way
that the flexible hose package (protective and
hydraulic hose) cannot be damaged by exter-
nal influences (such as being driven over by the
The center of gravity
load)
of the vehicle in-
cluding load must
5.2
be between 100
mm and 600 mm
!
from the stationary
bearing towards the
middle of the lift.
• Inspect the hazardous area. No person or object
fixed bearing
may stand in the working area of the lift, or on the
lift.
CG = center of gravity
!
fixed bearing 009
The center of gravity
of the vehicle in-
cluding load must
be between 100
mm and 600 mm
from the stationary
bearing towards the
middle of the lift.
CG = center of gravity
fixed bearing 010
• Lower the vehicle to the desired working height.
Push the „LOWER" button (4) (see figure 007).
• The system is equipped with an optional CE-STOP
During „LOWER" (4) to the lowest position, the sys-
tem stops at a height of 300 mm.
If required, use the ramps for safe acceptance
of the vehicle.

Lowering the vehicle

Warning! The hydraulic lines may not be driven
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
The vehicles cannot be lowered into the lowest
position without wheels. Otherwise the lift can-
not raise the load using its own force. The vehi-
cle could be damaged.
OPI_SPRINTER MOBIL 2500-3000_V3.1_DE-EN-FR-ES-IT
015