Deactivating The Timer; Deactivating The Acoustic Signals; Reducing The Maximum Crossing Over Height - Miele HS17 Mode D'emploi

en
 Press the OK button to confirm your
selection.
The settings will be displayed for ap‐
prox. three seconds.The robot vacuum
cleaner will now start to vacuum at the
same time each day.
The Timer indicator  lights up to
show that the timer has been activa‐
ted.
To alter the entries, proceed as descri‐
bed previously.

Deactivating the timer

 Press the Timer button on the remote
control briefly.
The Timer indicator  will go out.
Activating the timer / displaying a set
start time
 Press the Timer button on the remote
control briefly.
The Timer indicator  lights up, the set
start time is shown briefly and the robot
vacuum cleaner will start vacuuming at
the set start time.

Deactivating the acoustic signals

The acoustic signals are activated as
standard. You can deactivate and then
reactivate them.
48
 Press the OK button on the remote
control for at least three seconds.
OFF will appear briefly in the clock dis‐
play.
Acoustic signals for fault messages
cannot be deactivated.
Reducing the maximum crossing
over height
The robot vacuum cleaner is set as
standard so that it can negotiate a
height of up to 20 mm.
This allows it to vacuum carpets, cross
over thresholds, etc.
If you would like to reduce this height
(down to approx. 6 mm) in order to pro‐
tect chair or table legs, or lamps for ex‐
ample, you can deactivate the factory
default setting.
 Press the Base button on the remote
control for at least three seconds.
LO will appear in the clock display.
Press the Base button again for at least
three seconds if you want to reactivate
the maximum crossing over height of
20 mm. HI will appear in the clock dis‐
play.