Stihl HTE 60 Notice D'emploi page 48

English
STIHL recommends you use the STIHL
filler nozzle for chain oil (special
accessory).
Closing
Grip must be vertical:
Fit the cap – marks on tank cap and
N
oil tank must line up.
Press the cap down as far as stop.
N
While holding the cap depressed,
N
turn it clockwise until it engages in
position.
46
The marks on the cap and oil tank are
then in alignment.
Fold the grip down.
N
Tank cap is locked.
If the oil level in the tank does not go
down, the reason may be a problem in
the oil supply system: Check chain
lubrication, clean the oilways, contact
your dealer for assistance if necessary.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
If the tank cap cannot be locked in the oil
tank opening
Bottom of cap is twisted in relation to
top.
Remove the cap from the oil tank
N
and check it from above.
1
Left: Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right: Bottom of cap in correct posi-
tion – inner mark is under the
grip. It is not in line with the
outer mark.
HTE 60