Cleaning The Navigation Sensors - Bosch BCR1 Mode D'emploi

Cleaning and care
47 a
b
c
108
Care tips
Do not use pointed or sharp cleaning aids.
Do not use cleaning products containing alcohol or spi-
rits.
Do not use abrasive cloths or cleaning agents.

Cleaning the navigation sensors

!
Caution
The sensors being dirty may cause the robot vacuum
to malfunction. The sensors should be cleaned regu-
larly to keep the robot vacuum working at its best.
Note
To avoid scratching the top of the appliance, place it on
a soft surface when turning it over.
47
Fig.
a) Clean the drop sensors with a soft cloth or a brush.
b) Clean the bottom sensor window on the front of the
robot vacuum with a soft cloth or a brush.
c) Check the (open) top sensor window for foreign bo-
dies and remove these if present.
en