DeWalt D55153 Guide D'utilisation page 6

WARNING: RISK OF ELECTRICAL SHOCK
WHAT CAN HAPPEN
• Your air compressor is powered
by electricity. Like any other
electrically powered device, If it
is not used properly it may cause
electric shock.
• Repairs attempted by unqualified
personnel can result in serious
injury or death by electrocution.
• Electrical Grounding: Failure
to provide adequate grounding
to this product could result in
serious injury or death from
electrocution. See Grounding
Instructions under Installation.
HOW TO PREVENT IT
• Never operate the compressor
outdoors when it is raining or in
wet conditions.
• Never operate compressor
with protective covers removed
or damaged.
• Any electrical wiring or repairs
required on this product should
be performed by a D WALT factory
e
service center or a D WALT
e
authorized service center in
accordance with national and local
electrical codes.
• Make certain that the electrical
circuit to which the compressor is
connected provides proper electrical
grounding, correct voltage and
adequate fuse protection.
WARNING: RISK FROM FLYING OBJECTS
WHAT CAN HAPPEN
• The compressed air stream
can cause soft tissue damage
to exposed skin and can propel
dirt, chips, loose particles, and
small objects at high speed,
resulting in property damage or
personal injury.
WARNING: RISK OF HOT SURFACES
WHAT CAN HAPPEN
• Touching exposed metal such
as the compressor head,
engine head, engine exhaust
or outlet tubes, can result in
serious burns.
6
HOW TO PREVENT IT
• Always wear certified safety
equipment: ANSI Z87.1 eye
protection (CAN/CSA Z94.3)
with side shields when using
the compressor.
• Never point any nozzle or sprayer
toward any part of the body or at
other people or animals.
• Always turn the compressor off
and bleed pressure from the air
hose and air tank before attempting
maintenance, attaching tools
or accessories.
HOW TO PREVENT IT
• Never touch any exposed metal
parts on compressor during or
immediately after operation.
Compressor will remain hot for
several minutes after operation.
• Do not reach around protective
shrouds or attempt maintenance
until unit has been allowed to cool.