Animal (Dynamic) Weighing; Manual Mode; Auto Mode - Adam Equipment Eclipse EBL Série Notice D'utilisation

EN
10.4.4

Animal (Dynamic) Weighing

The balance can be set to weigh animals or unstable/moving items. This is commonly
referred to as 'Animal' or 'Dynamic' weighing mode. The balance will collect the weight
over a period of time to arrive at an average value and display the value until the operator
resets the balance. The actual weighing process can begin either automatically when the
weight is placed on the pan, or when initiated by the operator. The weighing unit can be
selected as normal using the [Unit] and [Select] keys, before starting the dynamic
weighing process.
Steps:
Press [Mode] and then the [Up] or [Down] key to cycle through available modes. When
Animal Animal Animal Animal
the " " symbol is displayed, press [Select] to enter dynamic weighing mode.
Animal Animal
Animal Animal
" r r r r UN UN" will now be displayed on the screen.
UN UN
Press [Up] or [Down] to select "RUN
up the balance for dynamic weighing (see section 10.4.4.3 on Dynamic Weighing Setup
Parameters).
Once Dynamic Weighing has started running, only the [Print] and [Mode] keys are lit.
[Print] pauses the sequence. The balance will display "PAvSEd
current calculated average weight. To resume, press [Print] again, or if you do not
wish to continue then pressing [Mode] will display "StOPPED
final average value.
[Mode] stops the operation. The balance will display "StOPPE
final average value.
Once Dynamic Weighing run has completed or been stopped, the final value will remain on
displayed on screen until the user presses either [Select] or [Mode] to go back to "rUN
weigh another item, or [
indicating that print output to a connected device is available. Print output will be the
measured weight as shown on screen.
10.4.4.1

MANUAL MODE

When the balance is in the "MmANvAL
If [Select] is pressed when "rvN
Place the item on the pan and press [Select] again.
After the pre-configured delay and test time have elapsed (see section 10.4.4.3 on
Dynamic Weighing Setup Parameters), the "
Remove the item from the pan. Press [Mode] to go back to "rUN
[ 0/T] to return to normal weighing.
10.4.4.2

AUTO MODE

When the balance is in the "AvTO
If [Select] is pressed when "rVN
© Adam Equipment Company 2015
RUN RUN RUN" for starting the dynamic weighing, or "SEtvP
0/T] to return to normal weighing. The [Print] key is also lit,
MmANvAL" mode:– MmANvAL MmANvAL
rvN rvN" is selected, balance will display "StArt rvN
Hold
AvTO AvTO AvTO" mode:–
rVN" is selected, the balance will display "LOAd P
rVN rVN
PAvSEd" and show the
PAvSEd PAvSEd
StOPPED" and then show the
StOPPED StOPPED
StOPPED D D D " and then show the
StOPPE StOPPE
StArt". StArt StArt
" symbol and the result will be displayed.
rUN" to weigh another item, or
rUN rUN
26
3016612482 Rev1-Aug15
SEtvP" to set SEtvP SEtvP
rUN" to rUN rUN
LOAd P".
LOAd P LOAd P