Adam Equipment Eclipse EBL Série Notice D'utilisation page 44

EN
Press [Select]. "0 0 0 0 " will be displayed. Enter the current passcode (OLD)
PC OPER PC OPER PC OPER PC OPER
first and press [Select]. If correctly entered then "NEW" will be displayed
briefly followed by "0 0 0 0 ". Enter a new passcode if desired or press [Mode] or
[ 0/T] to leave the existing password unchanged and return to normal
weighing.
Note: A passcode set to zero will disable the security feature and allow
unlimited access.
PC SV PC PC PC SVPE SV SV PE PE PE Press [Select]. "0 0 0 0 " will be displayed. Enter the current passcode (OLD)
first and press [Select]. If correctly entered then "NEW" will be displayed
briefly followed by "0 0 0 0 ". Enter a new passcode if desired or press [Mode] or
[ 0/T] to leave the existing password unchanged and return to normal
weighing.
Note: A passcode set to zero will disable the security feature and allow
unlimited access.
If a passcode is incorrectly entered then the message "ER CODE
will return to "PC OPER PC OPER" or "PC SV PC OPER PC OPER
Forgotten Passcodes:
Keep a record of the passcode to ensure you can access this section again. If however
you have forgotten your passcode you can still gain access by entering a universal code.
If you have forgotten the current passcode a code of "15" will always allow you to enter the
Supervisor area. Using the Supervisor menus, go to PASSCODE section. Reset the
Operator or Supervisor passcode using "15
© Adam Equipment Company 2015
PC SVPE PC SV PC SV PE". PE PE
15" as the old passcode when prompted.
15 15
ER CODE" will flash and the display
ER CODE ER CODE
42
3016612482 Rev1-Aug15