Adam Equipment Eclipse EBL Série Notice D'utilisation page 30

EN
selected then it will not be accepted and "ER LOW
by return to the time entry screen again.
To confirm the desired value, press [Select] or to escape without changing the value,
press [Mode].
10.4.4.3.4 Test time
Press [Select] when "TESt t
seconds over which the balance will average to compute the final weight. The Test time
value can be changed to between 10 - 99 seconds using the keypad numeric entry
method. If a value outside this range is selected then it will not be accepted and "ER LOW
or "ER HIGH ER HIGH" will be displayed followed by return to the time entry screen again. ER HIGH ER HIGH
To confirm the desired value, press [Select] or to escape without changing the value,
press [Mode].
© Adam Equipment Company 2015
ER LOW ER LOW" or "ER HIGH
"TEST T TEST T" TEST T TEST T
TESt t" is shown and the display will next show the number of
TESt t TESt t
ER LOW ER HIGH" will be displayed followed ER HIGH ER HIGH
28
3016612482 Rev1-Aug15
ER LOW"
ER LOW ER LOW