Supervisor Menus; Enable Weighing Units; Enable Weighing Modes; Enable Serial Interface Parameters - Adam Equipment Eclipse EBL Série Notice D'utilisation

EN
13

SUPERVISOR MENUS

Pressing the [Select] key while in normal weighing gives access to the menus.
When [Select] is pressed and the Supervisor Passcode is not enabled the display will
allow access to the Supervisor menus. If passcode is enabled, the balance will ask for it
by displaying "PASS CD PASS CD" shortly followed by displaying "0 0 0 0 ". PASS CD PASS CD
If a passcode is incorrectly entered then the message "ER CODE
will return to "PC OPER PC OPER" or "PC Sv
PC OPER PC OPER
If the passcode has been enabled and correctly entered, the balance will allow the
operator to access the Supervisor's menus by which the user can enable/disable weighing
units or modes, set balance parameters for the conditions, set time and date, set
parameters for the RS-232 interface, calibration parameters and security parameters.
The display will show the first menu item "vNITS
through the main menu items and pressing [Select] will enter the sub-menu, or options
can be set. Press [Mode] to exit out of a sub-menu, or [
weighing

13.1 ENABLE WEIGHING UNITS

When "vNITS vNITS vNITS" is displayed, press [Select]. The right hand side of the display will show the vNITS
symbol for the first unit, e.g. carats, ct, together with its enable state "OFF
Supervisor can then enable or disable the carats unit by using [Up] or [Down]. Pressing
[Select] will confirm the setting and will advance to the next weighing unit. Repeat for
each weighing unit in turn. Note: Grams, g, is always enabled.
Press [Mode] to advance to setting of the next menu or press [
normal weighing

13.2 ENABLE WEIGHING MODES

The same steps are followed to enable or disable the weighing modes:
Press [Select] when "MOdES
Parts Parts Parts Parts
Parts Counting ("
or disable the parts counting mode by using [Up] or [Down]. Pressing [Select] will confirm
the setting and will advance to the next weighing mode. Repeat for each mode in turn.
Press [Mode] to advance to setting of the next menu, or press [
normal weighing

13.3 ENABLE SERIAL INTERFACE PARAMETERS

The parameters affecting the serial interface are set in a similar manner to the other
parameters.
Note: The balance must be power-cycled to apply any changes to serial port settings.
Press [Select] when "SERIAL
© Adam Equipment Company 2015
PC SvPE PE".
PC Sv PC Sv PE PE
MOdES" is displayed. The upper display line will show the mode e.g. MOdES MOdES
") together with its enabled state "OFF" or "On". The user can enable
SERIAL" is displayed to enter the sub-menu. SERIAL SERIAL
ER CODE" will flash and the display
ER CODE ER CODE
vNITS". The [Up] and [Down] keys will cycle vNITS vNITS
0/T] to return to normal
38
3016612482 Rev1-Aug15
OFF" or "On OFF OFF On". The On On
0/T] to return to
0/T] to return to