Adam Equipment Eclipse EBL Série Notice D'utilisation page 29

EN
Place the item on the pan. The animal weighing test will begin automatically.
After the pre-configured delay and test time have elapsed (see section 10.4.4.3 on
Dynamic Weighing Setup Parameters), the "
Remove the item from the pan. Press [Mode] to go back to "rUN
[ 0/T] to return to normal weighing.
10.4.4.3
Animal (Dynamic) Weighing Setup Parameters
Animal
When the " " symbol is displayed, and you have selected "SEtvP
for dynamic weighing (see section 10.4.4.3 on Dynamic Weighing Setup Parameters):
Press [Select] to select "SEtvP
The display will show "MODE
select "AvtO AvtO" or "mmAnvAL mAnvAL".
AvtO AvtO mAnvAL mAnvAL
If "AvtO AvtO" or "mmAnvAL mAnvAL" is selected, the following 4 parameters are available:
AvtO AvtO mAnvAL mAnvAL
• Threshold
• Mode
• Delay
• Test time
10.4.4.3.1 Threshold
Press [Select] when "THRESH
weight of the item required by the balance to start the process for dynamic weighing. The
value shown will be the current value in the last selected unit.
The minimum threshold value can be changed from 1.0 to 100 grams using the keypad
numeric entry method. If a value outside this range is selected then it will not be accepted
and "ER LOW ER LOW" or "ER HIGH ER HIGH" will be displayed followed by return to the weight entry screen
ER LOW ER LOW ER HIGH ER HIGH
again.
To confirm the desired value, press [Select] or to escape without changing the value,
press [Mode].
10.4.4.3.2 Mode
Auto "AvtO AvtO AvtO AvtO" or Manual "mmAnvAL
[Select] is pressed becomes the active mode. Auto starts dynamic weighing test as soon
as weight exceeding a set threshold is loaded on the pan. Manual requires the user to
load the pan and then press a button before weighing commences.
10.4.4.3.3 Delay
Press [Select] when "DELAY
seconds pause before the sampling starts. The Delay value can be changed to between 0-
99 seconds using the keypad numeric entry method. If a value outside this range is
© Adam Equipment Company 2015
SEtvP SEtvP" to change the dynamic weighing mode settings. SEtvP
MODE MODE MODE". Press [Select] again and use the [Up] or [Down] keys to
"THRESH THRESH"
THRESH THRESH
"mode mode"
mode mode
"DELAY DELAY" DELAY DELAY
"TEST T TEST T"
TEST T TEST T
"THRESH THRESH THRESH" (For Auto mode only) THRESH
THRESH" is shown and the display will next show the minimum THRESH THRESH
"mode mode" mode mode
mAnvAL mAnvAL mAnvAL" modes are available. Whichever mode is visible when
"DELAY DELAY"
DELAY DELAY
DELAY" is shown and the display will next show the number of DELAY DELAY
HOLD
" symbol and the result will be displayed.
rUN" to weigh another item, or rUN rUN
SEtvP" to set up the balance SEtvP SEtvP
27
3016612482 Rev1-Aug15