Publicité
NOTE:
When the container is removed a negative value will be shown. If the
scale was tared just before removing the container, this value is the gross
weight of the container plus all products which were removed. The zero
indicator will also be on as the platform is back to the same condition it
was when [Zero] was pressed last.
Press [Tare] or [Zero] to remove the tare value and display zero. The
Net indicator will disappear.
10.3 WEIGHING
To determine the weight of a sample, first tare an empty container if used,
then place the sample in the container. The display will show the weight
and the unit of weight currently in use.
To change the weighing unit press the [Unit] key. The available weighing
units are the ones that are enabled by the user in the parameters section.
See section 13.2.
10.4 CHECK-WEIGHING
Check-weighing is a procedure to show a display or cause a beeper to
sound when the weight on the scale meets or exceeds the values stored
in memory. The memory holds values for a high limit and a low limit.
Either or both the limits can be used.
NOTE:
1. The beeper and the LEDs can each be set to OFF (See section 13.1).
The LCD display will indicate whenever the weight is within or
exceeds the limits by showing 'OK', 'HI' or 'LO'.
© Adam Equipment Company 2014
Mass on the balance is above the high limit
Mass is between the limits
Mass is below the low limit
12
Publicité
Chapitres
