Operations; Zeroing; Taring - Adam Equipment WBW Série Manuel

10.0

OPERATIONS

10.1 ZEROING

• You can press the [Zero] key at any time to set the zero point from
which all other weighing and counting is measured. This will usually
be necessary when the platform is empty. When the zero point is
obtained the display will show the zero indicator.
• The scale has an automatic re-zeroing function to account for minor
drifting or accumulation of material on the platform. However you
may need to press [Zero] to re-zero the scale if small amount of
weight is still shown when the platform is empty.

10.2 TARING

• Zero the scale by pressing [Zero]. The zero indicator will be on.
Place a container on the pan and its weight will be displayed.
• Press [Tare] when the reading is stable. The weight that was
displayed is stored as the tare value and it is subtracted from the
display, leaving zero on the display. The stable and Net indicator
will be on.
• As a product is added only the weight of the product will be shown.
The scale could be tared a second time if another type of product
was to be added to the first one. Again only the weight that is added
after taring will be displayed.
© Adam Equipment Company 2014
11