Programming Intermediate Positions I + Ii In Venetian Blind Operation - Becker Centronic VarioControl VC420-II Notice De Montage Et D'utilisation

Programming intermediate positions I
+ II in Venetian blind operation
If an intermediate position II (tilt position) has been pro-
grammed, the blind will automatically travel to this position
by double-tapping DOWN in the limit position (once the run-
ning time has elapsed). If an intermediate position I has also
been programmed, the blind is tilted as soon as intermediate
position I is reached.
Application
Venetian blind operation
Intermediate position II (tilt position)
This function lets you move the Venetian blind up again from
the lower limit position until the desired intermediate posi-
tion II is reached. Both limit positions must be set before in-
termediate position II is set.
Programming intermediate position II (tilt position)
Move the blind from the lower limit position to the desired intermediate posi-
tion II.
First press and hold the STOP button and, within the next 3 seconds, press
and hold the UP button. Keep both buttons depressed until
▻ the receiver confirms.
► Intermediate position II is now saved.
Checking intermediate position II (tilt position)
Press the UP button twice within one second.
► The blind moves to intermediate position II.
Function
Tilting
41 - en