Toggling Between Venetian Blind And Awning Mode; Programming - Becker Centronic VarioControl VC470-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Toggling between venetian blind and awning
Press the programming button for 3 seconds on the master transmitter until the
receiver acknowledges it.
Subsequently press the programming button and additionally the Up/Stop/
Down button for 10 seconds until the receiver acknowledges it.
Toggling has now been completed.
Intermediate position I
Note
The intermediate position I can be in any curtain position of your
choosing, situated between the highest and lowest limit position. Both
limit positions must be set before intermediate position I is set.
The curtain runs to the intermediate position I from the upper limit po-
sition.
Setting the intermediate position I
1. Travel the curtain from the upper limit position to the desired intermediate
position I.
2. Press the STOP button and, within 3 seconds, also press the DOWN button
and hold the two buttons down.
The curtain shifts to confirm.
The intermediate position I is now saved.
Checking the intermediate position I
1. Press the DOWN button twice within one second.
The curtain runs to the intermediate position I.
Deleting the intermediate position I
1. Travel the curtain to the intermediate position I.
2. Press the STOP button and, within 3 seconds, also press the DOWN button
and hold the two buttons down.
The curtain shifts to confirm.
The intermediate position I is now deleted.
24
mode

Programming